Nissan Altima 2007-2012 Service Manual: Preparation
Special Service Tool
The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.
Commercial Service Tool
Precaution
Precaution for Supplemental Restraint System
(SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER ...
On-vehicle maintenance
FRONT WHEEL HUB
Inspection
• Move wheel hub and bearing assembly in the axial direction by hand. Make
sure there is no looseness of
wheel bearing.
Axial end play : 0.05 mm (0.002 in) or less
...
Other materials:
On board diagnostic (OBD) system
Trouble Diagnosis Introduction
CAUTION:
• Do not use electrical test equipment on any circuit related to the SRS unless
instructed to do so in
this Service Manual. SRS wiring harnesses can be identified by yellow and/or
orange harness connectors.
• Do not attempt to repair, splice or m ...
Measurement of weights
Secure loose items to prevent weight
shifts that could affect the balance of your
vehicle. When the vehicle is loaded, drive
to a scale and weigh the front and the rear
wheels separately to determine axle
loads. Individual axle loads should not exceed
either of the gross axle weight ratings
( ...
Disassembly and assembly
FRONT DRIVE SHAFT
Disassembly and Assembly (Left Side)
1. Circlip
2. Dust shield
3. Slide joint housing
4. Snap ring
5. Spider assembly
6. Stopper ring
7. Boot band
8. Boot
9. Shaft
10. Damper band
11. Damper
12. Boot band
13. Boot
14. Ball cage / Steel ball / Inner race assembly
...