Nissan Altima 2007-2012 Service Manual: Preparation

Special Service Tools

The actual shapes of Kent-Moore tools may differ from those of special service tools illustrated here.

Commercial Service Tools

    Precaution
    Supplemental Restraint System (SRS) "AIR B AG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used al ...

    Symptom diagnosis
    SQUEAK AND RATTLE TROUBLE DIAGNOSES Work Flow CUSTOMER INTERVIEW Interview the customer if possible, to determine the conditions that exist when the noise occurs.Use the Diagnostic Worksheet d ...

    Other materials:

    P0826 manual mode switch
    Description Manual mode switch is installed in CVT control device. The manual mode switch sends shift up and shift down switch signals to TCM. TCM sends the switch signals to combination meter via CAN communication line. Then manual mode switch position is indicated on the CVT position ind ...

    Multiport fuel injection system
    System Diagram System Description INPUT/OUTPUT SIGNAL CHART *1: This sensor is not used to control the engine system under normal conditions. *2: This signal is sent to the ECM through CAN communication line. *3: ECM determines the start signal status by the signals of engine speed and ...

    On-vehicle rep
    BCM (BODY CONTROL MODULE) Removal and Installation REMOVAL CAUTION: Before replacing BCM, perform "READ CONFIGURATION" to save or print current vehicle specification. Refer to BCS-5, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Description". 1. Remove the combinati ...