Nissan Altima 2007-2012 Service Manual: Push button ignition switch
Removal and Installation
REMOVAL
1. Remove the cluster lid A assembly. Refer to IP-12, "Removal and Installation".
2. Release the pawls (A) and remove the push-button ignition switch (1) from cluster lid A.
INSTALLATION
Installation is in the reverse order of removal.
Key slot
Removal and Installation
REMOVAL
1. Remove the instrument lower panel LH. Refer to IP-12, "Removal and
Installation".
2. Disconnect key slot connector.
3. Remove the key slot scre ...
Other materials:
P0850 PNP Switch
Description
When the selector lever position is P or N, park/neutral position (PNP)
signal from the TCM is sent to ECM
(CVT models).
When the selector lever position is Neutral position, park/neutral position
(PNP) switch is ON. ECM detects the
position because the continuity of the line ( ...
Starting the engine
1. Apply the parking brake.
2. Move the shift lever to P (Park) or N (Neutral).
P (Park) is recommended.
The starter is designed not to operate if
the shift lever is in any of the driving
positions.
3. Push the ignition switch to the ON position.
Depress the brake pedal and push the ign ...
P0868 secondary pressure down
Description
The pressure control solenoid valve B (secondary pressure solenoid valve)
regulates the secondary pressure
to suit the driving condition in response to a signal sent from the TCM.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
CAUTION:
Always drive vehicle at a safe ...