Nissan Altima 2007-2012 Service Manual: Push button ignition switch

Removal and Installation

REMOVAL

1. Remove the cluster lid A assembly. Refer to IP-12, "Removal and Installation".

2. Release the pawls (A) and remove the push-button ignition switch (1) from cluster lid A.

INSTALLATION

Installation is in the reverse order of removal.

    Key slot
    Removal and Installation REMOVAL 1. Remove the instrument lower panel LH. Refer to IP-12, "Removal and Installation". 2. Disconnect key slot connector. 3. Remove the key slot scre ...

    Other materials:

    P0420 three way catalyst function
    DTC Logic DTC DETECTION LOGIC The ECM monitors the switching frequency ratio of air fuel ratio (A/F) sensor 1 and heated oxygen sensor 2. A three way catalyst (manifold) with high oxygen storage capacity will indicate a low switching frequency of heated oxygen sensor 2. As oxygen storage c ...

    NISSAN vehicle immobilizer system
    The NISSAN Vehicle Immobilizer System will not allow the engine to start without the use of a registered key. Never leave these keys in the vehicle. FCC Notice: For USA: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This devic ...

    Normal operating condition
    Description FUEL CUT CONTROL (AT NO LOAD AND HIGH ENGINE SPEED) If the engine speed is above 1,800 rpm under no load (for example, the selector lever position is neutral and engine speed is over 1,800 rpm) fuel will be cut off after some time. The exact time when the fuel is cut off varies b ...