Nissan Altima (L32) 2007-2012 Service Manual ≻ Rear suspension ≻ On-vehicle repair ≻ Radius rod

Nissan Altima (L32) 2007-2012 Service Manual: Radius rod

Removal and Installation

Removal

1. Remove the rear suspension assembly. Refer to RSU-12, "Removal and Installation".

2. Remove the radius rod using power tools.

Installation

Installation is in the reverse order of removal.

• Check the rear wheel alignment and adjust if necessary. Refer to RSU-18, "Rear Wheel Alignment (Unladen*)".

Front lower link

Removal and Installation Removal 1. Remove the front lower link nut and bolt from the knuckle side and the adjusting bolt and nut from the suspension member side using power tools. • Do not r ...

Rear stabilizer

Removal and Installation Removal 1. Disconnect the stabilizer bar from connecting rod, using power tools. 2. Remove the stabilizer bar clamps and bushings using power tools. 3. Remove the sta ...

Other materials:

Operating tips
The sunload sensor, located on the top center of the instrument panel, helps the system maintain a constant temperature. Do not put anything on or around this sensor. When the climate system is in automatic operation and the engine coolant temperature and outside air temperature are low, the ...

Tire Pressure Monitoring System (TPMS)
Each tire, including the spare (if provided), should be checked monthly when cold and inflated to the inflation pressure recommended by the vehicle manufacturer on the vehicle placard or tire inflation pressure label. (If your vehicle has tires of a different size than the size indicated on the vehi ...

I-FCW system limitations
Illustration A Illustration B WARNING Listed below are the system limitations for the I-FCW system. Failure to operate the vehicle in accordance with these system limitations could result in serious injury or death. The I-FCW system cannot detect all vehicles under all conditions. The radar se ...