Nissan Altima 2007-2012 Service Manual: Rear door speaker
Removal and Installation - Sedan
REMOVAL
1. Remove the rear door finisher. Refer to INT-34, "Removal and Installation".
2. Remove the rear door speaker screws (A), then disconnect the rear door speaker connector and remove the rear door speaker (1).
INSTALLATION
Installation is in the reverse order of removal.
Front door speaker
Removal and Installation REMOVAL 1. Remove the front door finisher. Refer to INT-12, "Removal and Installation" (coupe) and INT-34, "Removal and Installation" (sedan). 2. R ...Rear tweeter
Removal and Installation - Coupe REMOVAL 1. Remove the rear parcel shelf finisher. Refer to INT-17, "Removal and Installation". 2. Remove the rear tweeter speaker screws (A) and remov ...Other materials:
Oil cooler
Removal and Installation
1. Oil filter
2. Oil cooler bolt
3. Water pipe
4. Water hose
5. Oil cooler
6. O-ring
7. Oil pan
8. Water pipe
9. Relief valve
10. Water drain plug
11. Copper gasket
12. Water connector
WARNING:
Be careful not to get burned, engine coolant and engine oil may ...
Periodic maintenance
Introduction of Periodic Maintenance
Two different maintenance schedules are provided, and should be used,
depending upon the conditions in
which the vehicle is mainly operated. After 60,000 miles (96,000 km) or 48
months, continue the periodic
maintenance at the same mileage/time intervals.
...
Accelerator pedal released position
learning
Description
Accelerator Pedal Released Position Learning is a function of ECM to learn
the fully released position of the
accelerator pedal by monitoring the accelerator pedal position sensor output
signal. It must be performed each
time harness connector of accelerator pedal position sensor ...