Nissan Altima 2007-2012 Service Manual: Rear floor ducts

Removal and Installation

REMOVAL

1. Remove the floor carpet. Refer to INT-19, "Removal and Installation".

2. Remove the rear floor duct (RH, LH) clips.

3. Remove the rear floor ducts (RH, LH).

INSTALLATION

Installation is in the reverse order of removal.

    Rear ventilator ducts
     Removal and Installation Removal 1. Remove the floor carpet. Refer to INT-19, "Removal and Installation". 2. Remove the rear ventilator duct (center). Installation Installation ...

    Other materials:

    Oil pressure switch signal circuit
    Description Detects the engine oil pressure and transmits the oil pressure switch signal to the IPDM E/R. Component Function Check 1.COMBINATION METER INPUT SIGNAL 1. Select “METER/M&A” on CONSULT-III. 2. Monitor “OIL W/L” of “DATA MONITOR” while operating ignition switch. ...

    Automatic speed control device (ASCD)
    System Diagram System Description INPUT/OUTPUT SIGNAL CHART *: This signal is sent to the ECM through CAN communication line BASIC ASCD SYSTEM Refer to Owner's Manual for ASCD operating instructions. Automatic Speed Control Device (ASCD) allows a driver to keep vehicle at predetermin ...

    Vehicle Information Display
    The vehicle information display is located to the left of the speedometer. It displays such items as: ● Vehicle settings ● Trip computer information ● Drive system warnings and settings (if so equipped) ● Cruise control system information ● NISSAN Intelligent K ...