Nissan Altima 2007-2012 Service Manual: Rear LH
Description
Door glass moves UP/DOWN by receiving the signal from main power window and door lock/unlock switch or rear power window switch LH.
Component Function Check
1. CHECK REAR POWER WINDOW MOTOR LH CIRCUIT
Does rear power window motor LH operate with main power window and door lock/unlock switch or rear power window switch LH? Is the inspection result normal? YES >> Rear power window motor LH is OK.
NO >> Refer to PWC-117, "REAR LH : Diagnosis Procedure"
Diagnosis Procedure
Rear Power Window Motor LH Circuit Check
1. CHECK REAR POWER WINDOW SWITCH LH OUTPUT SIGNAL
1. Disconnect rear power window motor LH.
2. Turn ignition switch ON.
3. Check voltage between rear power window motor LH connector and ground.
Is the measurement value within the specification? YES >> GO TO 2
NO >> Check rear power window switch LH. Refer to PWC-118, "REAR LH : Component Inspection".
2. CHECK HARNESS CONTINUITY
1. Turn ignition switch OFF.
2. Disconnect rear power window switch LH.
3. Check continuity between rear power window switch LH connector (A) and rear power window motor LH connector (B).
4. Check continuity between rear power window switch LH connector (A) and ground.
Is the inspection result normal? YES >> GO TO 3
NO >> Repair or replace harness.
3. CHECK REAR POWER WINDOW MOTOR LH
Check rear power window motor LH.
Refer to PWC-118, "REAR LH : Component Inspection".
Is the inspection result normal? YES >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
NO >> Replace rear power window motor LH. Refer to GW-14, "Removal and Installation".
Component Inspection
1. CHECK REAR POWER WINDOW MOTOR LH
Does motor operate by connecting the battery voltage directly to rear power window motor LH?
Is the inspection result normal? YES >> Rear power window motor LH is OK.
NO >> Replace rear power window motor LH. Refer to GW-14, "Removal and Installation".
Passenger side
Description
Door glass moves UP/DOWN by receiving the signal from main power window and
door lock/unlock switch or
power window and door lock/unlock switch RH.
Component Function Check
1. CHECK ...
Rear RH
Description
Door glass moves UP/DOWN by receiving the signal from main power window and
door lock/unlock switch or
rear power window switch RH.
Component Function Check
1. CHECK POWER WIND ...
Other materials:
P0550 PSP Sensor
Description
Power steering pressure (PSP) sensor is installed to the power steering
high-pressure tube and detects a
power steering load.
This sensor is a potentiometer which transforms the power steering load into
output voltage, and emits the
voltage signal to the ECM. The ECM controls t ...
Key slot illumination
Description
Blinks when Intelligent Key insertion is required.
Component Function Check
1.CHECK FUNCTION
Check key slot illumination (“KEY SLOT ILLUMI”) Active Test mode.
Is the inspection result normal?
YES >> Key slot function is OK.
NO >> Refer to SEC-313, "Diagn ...
P0011, P0021 IVT control
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P0011 or P0021 is displayed with DTC P0075 or P0081, first perform the
trouble diagnosis for
DTC P0075, P0081. Refer to EC-1191, "DTC Logic".
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previousl ...