Nissan Altima 2007-2012 Service Manual: Rear regulator
Exploded View
1. Rear door
2. Door glass run
3. Door glass
4. Inside seal
5. Partition sash
6. Rear window seal
7. Door rear, glass
8. Regulator assembly
9. Window motor
10. Water shield
Removal and Installation
REMOVAL
1. Remove the rear door finisher. Refer to INT-34, "Removal and Installation".
2. Remove the plastic vapor barrier, being careful not to tear/damage it.
3. Temporarily reconnect the power window switch to the door harness.
4. Operate the power window switch to raise/lower the door window until the glass mounting bolts (A) can be seen.
5. Remove the door glass bolts (A).
6. Raise up the door glass and hold with a suction lifter (A).
7. Disconnect the window motor connector.
8. Remove the window regulator bolts (A) and remove the window regulator from the rear door panel.
INSTALLATION
Installation is in the reverse order of removal.
• After installation, inspect and adjust as necessary.
Inspection
Inspection after Removal
Check the regulator assembly for the following items. If a malfunction is detected, replace or grease it.
• Gear wear
• Regulator deformation
• Grease condition for each sliding part
Apply multi-purpose grease at points (A) shown.
FINAL INSPECTION
• Make sure the glass is securely fit into the glass run groove.
• Lower the glass slightly [approx. 10 to 20 mm (0.39 to 0.79 in)], and make sure the clearance to the sash is parallel. If the clearance between the glass and sash is not parallel, loosen the regulator mounting bolts, guide rail mounting bolts, and glass and carrier plate mounting bolts to correct the glass position.
Rear door glass
Exploded View
1. Rear door
2. Door glass run
3. Door glass
4. Inside seal
5. Partition sash
6. Rear window seal
7. Door rear, glass
8. Regulator assembly
9. Window motor
10. Water shield
...
Side window glass
Components
1. Windshield glass
2. Spacer
3. Seal
4. Body side outer
5. Primer
6. Adhesive
7. Encapsulation
E. 7(0.28)
F. 12 (0.47)
G. 15 (0.59)
Removal and Installation
REMOVAL
1. Remov ...
Other materials:
Camshaft
Removal and Installation
1. Camshaft position sensor bracket (RH)
2. Camshaft brackets
3. No. 1 camshaft bracket (RH)
4. Camshaft (EXH) RH
5. Camshaft (INT) RH
6. Cylinder head (RH)
7. Cylinder head (LH)
8. Camshaft (EXH) LH
9. Camshaft (INT) LH
10. No. 1 camshaft bracket (LH)
11. Cams ...
Power window main switch
Description
• BCM supplies power.
• It operates each power window motor via corresponding power window switch and
makes window move up/
down when main power window and door lock/unlock switch is operated.
Component Function Check
Main Power Window And Door Lock/unlock Switch
1. ...
Fuel pressure
Inspection
FUEL PRESSURE RELEASE
1. Turn ignition switch ON.
2. Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode with CONSULT-III.
3. Start engine.
4. After engine stalls, crank it two or three times to release all fuel
pressure.
5. Turn ignition switch OFF.
1. Re ...