Nissan Altima 2007-2012 Service Manual: Rear ventilator grille

Removal and Installation

REMOVAL

Remove console rear finisher. Refer to IP-11, "Exploded View".

NOTE: The rear ventilator is part of the console rear finisher.

INSTALLATION

Installation is in the reverse order of removal.

    SIDE DEFROSTER GRILLES
    Removal and Installation REMOVAL Remove side defroster grilles using a suitable tool. CAUTION: Use a suitable tool to remove the grille to avoid damage to the instrument panel. INSTALLATION In ...

    Rear ventilator ducts
     Removal and Installation Removal 1. Remove the floor carpet. Refer to INT-19, "Removal and Installation". 2. Remove the rear ventilator duct (center). Installation Installation ...

    Other materials:

    Throttle valve closed position learning
     Description Throttle Valve Closed Position Learning is a function of ECM to learn the fully closed position of the throttle valve by monitoring the throttle position sensor output signal. It must be performed each time the harness connector of electric throttle control actuator or ECM ...

    Main line between dlc and abs circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the following terminals and connectors for damage, bend and loose connection (connector side and harness side). - Harness co ...

    P0703 stop lamp switch
    Description BCM detects ON/OFF state of the stop lamp switch and transmits the data to the TCM via CAN communication by converting the data to a signal. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION ...