Nissan Altima 2007-2012 Service Manual: Rear view camera
Diagnosis Procedure
1.CHECK POWER SUPPLY CIRCUIT (REAR VIEW CAMERA SIDE)
Check voltage between rear view camera harness connector and ground.
Is voltage reading approximately 6 volts? YES >> GO TO 4
NO >> GO TO 2
2.CHECK POWER SUPPLY CIRCUIT (CONTINUITY)
1. Turn ignition switch OFF.
2. Disconnect rear view camera and rear view camera control unit connectors.
3. Check continuity between rear view camera harness connector T7 (A) terminal 1 and rear view camera control unit harness connector B31 (B) terminal 8.
4. Check continuity between rear view camera harness connector T7 (A) terminal 1 and ground.
Are continuity test results as specified? YES >> GO TO 3
NO >> Repair harness or connector.
3.CHECK POWER SUPPLY CIRCUIT (CAMERA CONTROL UNIT SIDE)
1. Connect rear view camera control unit harness connector.
2. Turn ignition switch ON.
3. Check voltage between rear view camera control unit harness connector and ground.
Is voltage reading approximately 6 volts? YES >> Inspection End.
NO >> Replace rear view camera control unit. Refer to AV-458, "Removal and Installation - Coupe".
4.CHECK GROUND CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect rear view camera harness connector.
3. Check continuity between rear view camera harness connector B35 terminal 2 and ground.
Does continuity exist? YES >> Inspection End.
NO >> Repair harness or connector.
Rear view camera control unit
Diagnosis Procedure 1.CHECK FUSE Check that the following fuses of the rear view camera control unit are not blown. Are the fuses OK? YES >> GO TO 2 NO >> Be sure to eliminate cau ...Bose speaker AMP
Diagnosis Procedure 1.CHECK FUSE Check that the following fuses of the BOSE speaker amp. are not blown. Are the fuses OK? YES >> GO TO 2 NO >> Be sure to eliminate cause of ma ...Other materials:
NISSAN Intelligent Key® With Door and Trunk Request Switches
WARNING
● Radio waves could adversely affect
electric medical equipment. Those who
use a pacemaker should contact the
electric medical equipment manufacturer
for the possible influences before
use.
● The Intelligent Key transmits radio
waves when the buttons are pressed.
The F ...
Passenger seat belt warning system
System Diagram
System Description
The seat belt warning lamp (1) will remind the driver if the driver or
front passenger seat belt should be buckled. The system works in
conjunction with the occupant classification system. Refer to SRC-
10, "Occupant Classification System (OCS)".
...
Oil
Maintenance of Oil Quantity in Compressor
The oil in the compressor circulates through the system with the refrigerant.
Add oil to compressor when
replacing any component or after a large refrigerant leakage has occurred. It is
important to maintain the specified
amount.
If oil quantity is ...