Nissan Altima 2007-2012 Service Manual: Rear window defogger power supply and ground circuit

Description

Heats the heating wire with the power supply from the rear window defogger relay to prevent the rear window from fogging up.

Component Function Check

1. CHECK REAR WINDOW DEFOGGER

Check that the heating wire of rear window defogger is heated when turning the rear window defogger switch ON.

Is the inspection result normal? YES >> Rear window defogger is OK.

NO >> Refer to DEF-13, "Diagnosis Procedure".

Diagnosis Procedure

1. CHECK POWER SUPPLY CIRCUIT

1. Turn ignition switch ON.

2. Check voltage between rear window defogger connector and ground.


Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 2

NO >> GO TO 3

2. CHECK GROUND CIRCUIT

1. Turn ignition switch OFF.

2. Disconnect rear window defogger.

3. Check continuity between rear window defogger connector and ground.


Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 5

NO >> Repair or replace harness.

3. CHECK HARNESS CONTINUITY 1

1. Turn ignition switch OFF.

2. Disconnect condenser and rear window defogger.

3. Check continuity between condenser connector (A) and rear window defogger connector (B).


Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 4

NO >> Replace condenser. Refer to DEF-66, "Removal and Installation - Coupe" or DEF-66, "Removal and Installation - Sedan".

4. CHECK HARNESS CONTINUITY 2

1. Disconnect fuse block (J/B).

2. Check continuity between fuse block (J/B) connector (A) and condenser connector (B).


Is the inspection result normal?


Is the inspection result normal? YES >> GO TO 6

NO >> Replace or repair harness.

5. CHECK FILAMENT

Check filament.

Refer to DEF-14, "Component Inspection".

Is the inspection result normal? YES >> Refer to GI-42, "Intermittent Incident".

NO >> Repair filament. Refer to DEF-64, "Inspection and Repair".

6. CHECK INTERMITTENT INCIDENT

Check intermittent incident.

Refer to GI-42, "Intermittent Incident".

Is the inspection result normal? YES >> Check the following.

    Rear window defogger relay
    Description Power is supplied to the rear window defogger with BCM control. Component Function Check 1. CHECK REAR WINDOW DEFOGGER RELAY POWER SUPPLY CIRCUIT Check that an operation noise of rear ...

    Driver side door mirror defogger
    Description Heats the heating wire with the power supply from the rear window defogger relay to prevent the door mirror from fogging up. Component Function Check 1. CHECK DOOR MIRROR DEFOGGER ...

    Other materials:

    Rear regulator
    Exploded View 1. Rear door 2. Door glass run 3. Door glass 4. Inside seal 5. Partition sash 6. Rear window seal 7. Door rear, glass 8. Regulator assembly 9. Window motor 10. Water shield Removal and Installation REMOVAL 1. Remove the rear door finisher. Refer to INT-34, "Removal ...

    Power window main switch
    Reference Value TERMINAL LAYOUT PHYSICAL VALUES MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH Wiring Diagram Fail Safe FAIL-SAFE CONTROL Switches to fail-safe control when malfunction is detected in encoder signal that detects up/down speed and direction of door glass. ...

    Air bags, seat belts and child restraints
    1. Top tether strap anchor 2. Rear seat belts 3. Roof-mounted curtain side-impact supplemental air bag 4. Front seat-mounted side-impact supplemental air bag 5. Head restraints/headrests 6. Front seat belts 7. Side-impact pressure sensor (driver’s side shown; passenger’s side simil ...