Nissan Altima (L32) 2007-2012 Service Manual ≻ Audio, visual & navigation system bose audio without navigation ≻ Component diagnosis ≻ Power supply and ground circuit (sedan) ≻ Satellite radio tuner

Nissan Altima (L32) 2007-2012 Service Manual: Satellite radio tuner

Diagnosis Procedure

1.CHECK FUSES

Check that the following fuses are not blown.

Are the fuses OK? YES >> GO TO 2

NO >> If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse.

2.POWER SUPPLY CIRCUIT CHECK

1. Turn ignition switch OFF.

2. Disconnect satellite radio tuner (factory installed) connector B123.

3. Check voltage between the satellite radio tuner (factory installed) and ground.

Are the voltage results as specified? YES >> GO TO 3

NO >> • Check connector housings for disconnected or loose terminals.

• Repair harness or connector.

3.GROUND CIRCUIT CHECK

Inspect satellite radio tuner (factory installed) case ground.

Does case ground pass inspection? YES >> Inspection End.

NO >> Repair satellite radio tuner (factory installed) case ground.

Bose speaker AMP

Diagnosis Procedure 1.CHECK FUSE Check for blown fuses. Are the fuses OK? YES >> GO TO 2 NO >> Be sure to eliminate cause of malfunction before installing new fuse. 2.CHECK POWER ...

Bluetooth control unit

Diagnosis Procedure 1.CHECK FUSE Check that the following fuses of the Bluetooth control unit are not blown. Are the fuses OK? YES >> GO TO 2 NO >> Be sure to eliminate cause ...

Other materials:

System temporarily unavailable
For vehicles with the 7 inch (18 cm) display When radar blockage is detected, the system will be deactivated automatically. The "Unavailable: Side Radar Obstruction" warning message will appear in the vehicle information display. The systems are not available until the conditions no longer exist. ...

Traffic Sign Recognition (TSR) (if so equipped)
The TSR system provides the driver with information about the most recently detected speed limit. The system captures the road sign information with the multi-sensing front camera unit A located on the windshield in front of the inside rearview mirror and displays the detected signs in the vehicle ...

How to switch the display
With the ignition switch in the ON position, press the CAMERA button or move the shift lever to the R (Reverse) position to operate the Intelligent Around View Monitor. The Intelligent Around View Monitor displays different split screen views depending on the position of the shift lever. Press the ...