Nissan Altima 2007-2012 Service Manual: Service data and specifications(SDS)
Wheel Alignment (Unladen*)
Fuel, radiator coolant and engine
oil full. Spare tire, jack, hand tools and mats in designated positions.
Fuel,
radiator coolant and engine oil full. Spare tire, jack, hand tools and mats in
designated positions.
Ball Joint
Wheelarch Height (Unladen*1)
*1: Fuel, engine coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions.
COUPE
*1: Fuel, engine coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions.
Disassembly and assembly
FRONT COIL SPRING AND STRUT
Disassembly and Assembly
DISASSEMBLY
1. Install Tool to strut and secure it in a vise.
Tool number : ST35652000 ( — )
CAUTION:
When installing Tool, wrap a shop ...
Rear suspension
...
Other materials:
Fuel pump
Description
*: ECM determines the start signal status by the signals of engine speed and
battery voltage.
The ECM activates the fuel pump for several seconds after the ignition switch is
turned ON to improve engine
start ability. If the ECM receives a engine speed signal from the camshaf ...
B1017 – b1022 occupant classification
system
Description
DTC B1017 – B1022 OCCUPANT CLASSIFICATION SYSTEM (OCS)
The occupant classification system control unit is wired to the air bag
diagnosis sensor unit. The air bag diagnosis
sensor unit will monitor the occupant classification system for control unit and
sensor mat failures and
...
P2014 tumble control valve position
sensor
Description
Tumble control valve position sensor is built into the tumble control
valve actuator (2).
1 : Intake manifold adapter
3 : Tumble control valve
The sensor consists of a permanent magnet and Hall IC. It senses
the valve shaft movement and feeds the voltage signals to the ECM.
DTC ...