Nissan Altima 2007-2012 Service Manual: Service data and specifications (SDS)

STARTER MOTOR

Starter

    On-vehicle repair
    STARTER MOTOR Removal and Installation M/T MODELS Removal 1. Disconnect the negative battery terminal. 2. Disconnect the starter motor harness connectors. 3. Remove the two starter motor bol ...

    Other materials:

    P0146 HO2S3
    Description The heated oxygen sensor 3, after HC adsorption catalyst (Under floor), monitors the oxygen level in the exhaust gas on each bank. This sensor is made of ceramic zirconia. The zirconia generates voltage from approximately 1V in richer conditions to 0V in leaner conditions. Unde ...

    Radiator
    Removal and Installation 1. Radiator 2. CVT oil cooler hose (if equipped) 3. Radiator hose (upper) 4. Radiator hose (lower) 5. Cooling fan 6. Reservoir tank 7. Reservoir hose 8. Radiator filler cap 9. Clamps A. To CVT (if equipped) B. To water outlet C. To water inlet WARNING: Never ...

    Oil pump fitting bolt
    Exploded View 1. Oil pump fitting bolt 2. O-ring 3. CVT assembly Removal and Installation Refer to the figure for removal and installation. CAUTION: • Do not reuse O-ring. • Apply CVT fluid to O-ring. • After installation is complete, check for CVT fluid leakage and CVT fluid ...