Nissan Altima 2007-2012 Service Manual: Steering switch

Description

When one of the steering wheel audio control switches is pushed, the resistance in steering switch circuit changes depending on which button is pushed.

Diagnosis Procedure

1.CHECK STEERING SWITCH RESISTANCE

1. Disconnect steering switch connector M88.

2. Check resistance between steering switch connector terminals.

Do the steering switches check OK? YES >> GO TO 2

NO >> Replace steering switch. Refer to AV-225, "Removal and Installation".

2.CHECK HARNESS

1. Turn ignition switch OFF.

2. Disconnect audio unit connector M43 and spiral cable connector M30.

3. Check continuity between audio unit harness connector M43 (A) and spiral cable harness connector M30 (B).

4. Check continuity between audio unit connector M43 (A) and ground.

Are the continuity results as specified? YES >> GO TO 3

NO >> Repair harness.

3.SPIRAL CABLE CHECK

1. Disconnect spiral cable connector M88.

2. Check continuity between spiral cable harness connector M30 (A) and M88 (B).

Does the spiral cable check OK? YES >> Inspection End.

NO >> Replace spiral cable. Refer to SR-8, "Removal and Installation".

    Rear speaker
    Description The audio unit sends audio signals to the rear speakers using the rear speaker circuits. Diagnosis Procedure 1.HARNESS CHECK 1. Disconnect audio unit connector M43 (A) and suspect s ...

    Communication signal circuit (coupe)
    SATELLITE RADIO TUNER  Description Communication signals are exchanged between the audio unit and satellite radio tuner using the communication circuits. Diagnosis Procedure 1.CHECK HARN ...

    Other materials:

    P0715 input speed sensor (pri speed sensor)
    Description The input speed sensor (primary speed sensor) detects the primary pulley revolution speed and sends a signal to the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has be ...

    Operating tips
    ● When the engine coolant temperature and outside air temperature are low, the air flow from the foot outlets may not operate for a maximum of 150 seconds. However, this is not a malfunction. After the coolant temperature warms up, air flow from the foot outlets will operate normally. ...

    Disassembly and assembly
    FRONT COIL SPRING AND STRUT Disassembly and Assembly DISASSEMBLY 1. Install Tool to strut and secure it in a vise. Tool number : ST35652000 ( — ) CAUTION: When installing Tool, wrap a shop cloth around strut to protect it from damage. 2. Slightly loosen piston rod lock nut. WARNING: ...