Nissan Altima 2007-2012 Service Manual: STRG branch line circuit

Diagnosis Procedure

INSPECTION PROCEDURE

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the terminals and connectors of the steering angle sensor for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

1. Disconnect the connector of steering angle sensor.

2. Check the resistance between the steering angle sensor harness connector terminals.

Is the measurement value within the specification? YES >> GO TO 3.

NO >> Repair the steering angle sensor branch line.

3.CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the steering angle sensor. Refer to BRC-207, "Wiring Diagram - Coupe" or BRC-215, "Wiring Diagram - Sedan".

Is it normal? YES (Present error)>>Replace the steering angle sensor. Refer to BRC-242, "Removal and Installation" .

YES (Past error)>>Error was detected in the steering angle sensor branch line.

NO >> Repair the power supply and the ground circuit.

    M&A branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

    ABS branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

    Other materials:

    P2423 HC adsorption catalyst function
    DTC Logic DTC DETECTION LOGIC The ECM monitors the phase gap between heated oxygen sensor 2 signal and heated oxygen sensor 3 signal. The phase gap between heated oxygen sensor 2 signal and heated oxygen sensor 3 signal becomes small as the HC adsorption catalyst (under floor) is deteriorate ...

    On-vehicle repair
    POWER WINDOW MAIN SWITCH Removal and Installation REMOVAL 1. Remove the power window main switch finisher (2). Refer to INT-34, "Removal and Installation". 2. Power window main switch (1) is removed from power window main switch finisher (2) using a suitable tool (A). CAUTION: ...

    P0130, P0150 A/F sensor 1
    Description The air fuel ratio (A/F) sensor 1 is a planar one-cell limit current sensor. The sensor element of the A/F sensor 1 is composed an electrode layer, which transports ions. It has a heater in the element. The sensor is capable of precise measurement = 1, but also in the lean and ...