Nissan Altima 2007-2012 Service Manual: STRG branch line circuit

Diagnosis Procedure

INSPECTION PROCEDURE

1.CHECK CONNECTOR

1. Turn the ignition switch OFF.

2. Disconnect the battery cable from the negative terminal.

3. Check the terminals and connectors of the steering angle sensor for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair the terminal and connector.

2.CHECK HARNESS FOR OPEN CIRCUIT

1. Disconnect the connector of steering angle sensor.

2. Check the resistance between the steering angle sensor harness connector terminals.

Is the measurement value within the specification? YES >> GO TO 3.

NO >> Repair the steering angle sensor branch line.

3.CHECK POWER SUPPLY AND GROUND CIRCUIT

Check the power supply and the ground circuit of the steering angle sensor. Refer to BRC-207, "Wiring Diagram - Coupe" or BRC-215, "Wiring Diagram - Sedan".

Is it normal? YES (Present error)>>Replace the steering angle sensor. Refer to BRC-242, "Removal and Installation" .

YES (Past error)>>Error was detected in the steering angle sensor branch line.

NO >> Repair the power supply and the ground circuit.

    M&A branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

    ABS branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors ...

    Other materials:

    Antenna AMP
    Removal and Installation - Coupe REMOVAL 1. Remove the rear pillar finisher RH. Refer to INT-20, "Exploded View". 2. Detach the antenna amp harness clip (B), disconnect the antenna amp connectors (A), remove the antenna amp screw (C) and remove the antenna amp (1). INSTALLATION ...

    Accelerator pedal released position learning
    Description Accelerator Pedal Released Position Learning is a function of ECM to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal position sensor output signal. It must be performed each time harness connector of accelerator pedal position sensor ...

    On-vehicle maintenance
    REAR SUSPENSION ASSEMBLY On-vehicle Service • Check the suspension parts for excessive play, cracks, wear or damage. Shake each rear wheel to check for excessive play. • Retighten all nuts and bolts to the specified torque. • Make sure that the cotter pin is installed. • Check ...