Nissan Altima 2007-2012 Service Manual: Sunroof does not operate antipinch function
Diagnosis Procedure
1. PERFORM INITIALIZATION PROCEDURE
Perform initialization procedure.
Refer to RF-6, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement".
Is the inspection result normal? >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Retained power operation does not
operate properly
Diagnosis Procedure
1.CHECK FRONT DOOR SWITCH
Check front door switch.
Refer to DLK-69, "Component Function Check".
Is the inspection result normal?
>> Check intermittent inc ...
Squeak and rattle trouble diagnoses
Work Flow
CUSTOMER INTERVIEW
Interview the customer if possible, to determine the conditions that exist
when the noise occurs.Use the Diagnostic
Worksheet during the interview to document the f ...
Other materials:
Accelerator pedal released position
learning
Description
Accelerator Pedal Released Position Learning is a function of ECM to learn
the fully released position of the
accelerator pedal by monitoring the accelerator pedal position sensor output
signal. It must be performed each
time the harness connector of the accelerator pedal p ...
P1805 brake switch
Description
Brake switch signal is applied to the ECM through the stop lamp switch when
the brake pedal is depressed.
This signal is used mainly to decrease the engine speed when the vehicle is
driving.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION ...
P0715 input speed sensor (pri speed
sensor)
Description
The input speed sensor (primary speed sensor) detects the primary pulley
revolution speed and sends a signal
to the TCM.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
CAUTION:
Always drive vehicle at a safe speed.
NOTE:
If “DTC CONFIRMATION PROCEDURE” has be ...