Nissan Altima 2007-2012 Service Manual: Trunk room trim & trunk lid finisher

Exploded View

TRUNK ROOM TRIM

1. Upper trunk finisher

2. Trunk lid finisher

3. Trunk side finisher (RH)

4. Trunk floor carpet

5. Trunk side finisher (LH)

6. Trunk spacer (LH)

7. Spare tire cover

8. Trunk net rear

9. Trunk spacer (RH)

10. Trunk rear finisher

11. Trunk net side

Removal and Installation

REMOVAL

TRUNK ROOM TRIM

1. Release the clips, then remove trunk floor carpet.

2. Remove trunk net rear and trunk net side (if equipped).

3. Release the clips, then remove trunk rear finisher.

4. Release the clips, then remove upper trunk finisher.

5. Release the clips, then remove trunk side finisher (RH/LH).

6. Remove spare tire cover and trunk spacers (RH/LH).

7. Release the clips and remove trunk lid finisher.

INSTALLATION

Installation is in the reverse order of removal.

    Headlining
    Exploded View 1. Headlining assembly (without sunroof) 2. Assist grip 3. Headlining assembly (with sunroof) 4. Front room/Map lamp assembly bracket 5. Front room/Map lamp assembly 6. Sunviso ...

    Other materials:

    Front seat-mounted side-impact supplemental air bag and roof-mounted curtain side-impact supplemental air bag systems
    The side air bags are located in the outside of the seatback of the front seats. The curtain air bags are located in the side roof rails. However, all of the information, cautions and warnings in this manual still apply and must be followed. The side air bags and curtain air bags are desig ...

    Spark plug
    Removal and Installation 1. Ignition coil 2. Spark plug 3. Rocker cover REMOVAL 1. Remove the ignition coil. Refer to EM-35, "Removal and Installation". 2. Remove the spark plug with a suitable spark plug wrench. INSPECTION AFTER REMOVAL • Do not use a wire brush for clean ...

    Seat belt buckle switch signal circuit
    Description Transmits a seat belt buckle switch signal to the combination meter. Component Function Check 1. CHECK COMBINATION METER INPUT SIGNAL Select “DATA MONITOR” for “METER/M&A” and check the “BUCKLE SW” monitor value. >> Inspection End. Diagnosis Procedure 1. ...