Nissan Altima 2007-2012 Service Manual: Tweeter (sedan)

Description

The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker amp. amplifies the audio signals before sending them to the front tweeters using the audio signal circuits.

Diagnosis Procedure

1.HARNESS CHECK

1. Disconnect BOSE speaker amp. connector B122 and suspect tweeter connector.

2. Check continuity between BOSE speaker amp. harness connector B122 (A) and suspect tweeter harness connector (B).

3. Check continuity between BOSE speaker amp. harness connector B122 (A) and ground.

Are continuity test results as specified? YES >> GO TO 2

NO >> • Check connector housings for disconnected or loose terminals.

• Repair harness or connector.

2.TWEETER SIGNAL CHECK

1. Connect BOSE speaker amp. connector B122 and suspect tweeter connector.

2. Turn ignition switch to ACC.

3. Push “POWER” switch.

4. Check the signal between BOSE speaker amp. harness connector B122 terminals with CONSULT-III or oscilloscope.

Are the audio signal voltage readings as specified? YES >> Replace suspect tweeter. Refer to AV-217, "Removal and Installation".

NO >> GO TO 3

3.HARNESS CHECK

1. Disconnect audio unit connector M43 and BOSE speaker amp.

connector B121.

2. Check continuity between audio unit harness connector M43 (A) and BOSE speaker amp. harness connector B121 (B).

3. Check continuity between audio unit harness connector M43 (A) and ground.

Are continuity test results as specified? YES >> GO TO 4

NO >> • Check connector housings for disconnected or loose terminals.

• Repair harness or connector.

4.TWEETER SIGNAL CHECK

1. Connect audio unit connector and BOSE speaker amp. connector.

2. Turn ignition switch ACC.

3. Push “POWER” switch.

4. Check the signal between audio unit harness connector M43 terminals with CONSULT-III or oscilloscope.

Are the audio signal voltage readings as specified? YES >> Replace BOSE speaker amp. Refer to AV-216, "Removal and Installation - Coupe".

NO >> Replace audio unit. Refer to AV-215, "Removal and Installation".

    Front tweeter (coupe)
    Description The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker amp. amplifies the audio signals before sending them to the front tweeters using the audio signal circui ...

    Center speaker
    Description The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker amp. amplifies the audio signals before sending them to the center speaker using the audio signal circui ...

    Other materials:

    Collision diagnosis
    For Frontal Collision Check the SRS components using the following table. • After the work is completed, perform self-diagnosis to check that no malfunction is detected. Refer to SRC- 12, "SRS Operation Check". SRS INSPECTION (FOR FRONTAL COLLISION) For Side and Rollover Co ...

    Power window main switch
    Reference Value TERMINAL LAYOUT PHYSICAL VALUES MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH Wiring Diagram Fail Safe FAIL-SAFE CONTROL Switches to fail-safe control when malfunction is detected in encoder signal that detects up/down speed and direction of door glass. S ...

    P0715 input speed sensor (pri speed sensor)
    Description The input speed sensor (primary speed sensor) detects the primary pulley revolution speed and sends a signal to the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has be ...