Nissan Altima 2007-2012 Service Manual: Washer tank

Removal and Installation

REMOVAL

1. Remove the washer tank filler tube (1).

2. Remove engine under cover.

3. Position the RH fender protector back. For Sedan Refer to EXT-40, "Removal and Installation". For Coupe Refer to EXT-19, "Removal and Installation" .

4. Disconnect the washer pump and washer fluid level sensor connectors (C), then detach the connector harness clip (B).

5. Remove the washer tank nuts (A), disconnect the washer pump hose and remove the washer tank (1).

INSTALLATION

Installation is in the reverse order of removal.

CAUTION: After installation, add Nissan specified fluid up to the upper level of washer tank inlet, and check for leaks. Refer to MA-12, "Fluids and Lubricants".

    Front washer nozzle
     Removal and Installation REMOVAL 1. Remove the cowl top cover For Sedan Refer to EXT-39, "Removal and Installation". For Coupe Refer to EXT-18, "Removal and Installation" ...

    Front washer pump
    Removal and Installation Front washer pump is not available seperately, it is part of the washer tank. Refer to WW-119, "WASHER TANK : Removal and Installation". ...

    Other materials:

    BCM branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the BCM for damage, bend and loose connection (unit side and connector side). Is the inspect ...

    B1150 – B1153 side curtain air bag module LH
    Description DTC B1150 – B1153 LH SIDE CURTAIN AIR BAG MODULE The LH side curtain air bag module is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor unit will monitor for opens and shorts in detected lines to the LH side curtain air bag module. PART LOCATION Refer t ...

    Anti-pinch system does not operate normally (driver side)
    Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement". Is the inspection result normal? YES >> GO TO 2 NO >> Repair or replace the mal ...