Nissan Altima 2007-2012 Service Manual: B210b starter control relay

Description

Starter control relay, integrated in IPDM E/R, permits the starter relay operation when in N or P position and the steering is locked or unlocked. It is installed in parallel with the starter relay.

DTC Logic

DTC DETECTION LOGIC

NOTE: • If DTC B210B is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-36, "DTC Logic".

• If DTC B210B is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to SEC-37, "DTC Logic".

DTC CONFIRMATION PROCEDURE

1.PERFORM DTC CONFIRMATION PROCEDURE

1. Turn the power supply position to start under the following conditions and wait for at least 1 second.

- CVT selector lever is in the P or N position.

- Depress the brake pedal

2. Check “Self diagnostic result” with CONSULT-III.

Is DTC detected? YES >> Refer to SEC-48, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.INSPECTION START

1. Turn ignition switch ON.

2. Check “Self diagnostic result” with CONSULT-III.

3. Touch “ERASE”.

4. Perform DTC Confirmation Procedure.

See PCS-45, "DTC Index".

Is the DTC B210B displayed again? YES >> Replace IPDM E/R. Refer PCS-48, "Removal and Installation".

NO >> Inspection End.

    B210a steering lock condition switch
    Description There are 2 switches in the steering unit. IPDM E/R compares those 2 switches conditions to judge the present steering status and transmit the result to BCM via CAN communication. DTC ...

    B210c starter control relay
    Description Starter control relay, integrated in IPDM E/R, permits the starter relay operation when in N or P position and the steering is locked or unlocked. It is installed in parallel with the ...

    Other materials:

    Control panel buttons — color screen with Navigation System (if so equipped)
    1. PWR button/VOL (volume) control knob 2. Display screen 3. ENTER / AUDIO button / TUNE / SCROLL knob 4. BACK button 5. MAP button* 6. NAV button* 7. button 8. (brightness control) button 9. button** 10. CAMERA button * For information regarding the Navigation system control butto ...

    DLC branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the data link connector for damage, bend and loose connection (connector side and harness side) ...

    Event Data Recorders (EDR)
    This vehicle is equipped with an Event Data Recorder (EDR). The main purpose of an EDR is to record, in certain crash or near crash-like situations, such as an air bag deployment or hitting a road obstacle, data that will assist in understanding how a vehicle’s systems performed. The EDR is ...