Nissan Altima 2007-2012 Service Manual: Component diagnosis
- U1000 can comm circuit
- U1010 control unit (can)
- B2013 ID discord, immu-strg
- B2014 chain of strg-immu
- B2108 steering lock relay
- B2109 steering lock relay
- B210a steering lock condition switch
- B210b starter control relay
- B210c starter control relay
- B210D starter relay
- B210E starter relay
- B210F PNP/clutch interlock switch
- B2110 PNP/clutch interlock switch
- B2190, P1610 nats antenna AMP
- B2191, P1615 difference of key
- B2192, P1611 ID discord, immu-ECM
- B2193, P1612 chain of ecm-immu
- B2555 stop lamp
- B2556 push-button ignition switch
- B2557 vehicle speed
- B2560 starter control relay
- B2601 shift position
- B2602 shift position
- B2603 shift position status
- B2604 PNP switch
- B2605 PNP switch
- B2606 steering lock relay
- B2607 steering lock relay
- B2608 starter relay
- B2609 steering status
- B260b steering lock unit
- B260c steering lock unit
- B260d steering lock unit
- B260f engine status
- B2612 steering status
- B2617 starter relay circuit
- B2619 BCM
- B261a push-button ignition switch
- B26e1 no reception of engine status signal
Diagnosis system (BCM)
COMMON ITEM
Diagnosis Description
BCM CONSULT-III FUNCTION
CONSULT-III performs the following functions via CAN communication with BCM.
SYSTEM APPLICATION
BCM can perform the following functio ...
U1000 can comm circuit
Description
CAN (Controller Area Network) is a serial communication line for real time
applications. It is an on-vehicle multiplex
communication line with high data communication speed and excell ...
Other materials:
Rear parcel shelf finisher
Exploded View
1. High mounted stop lamp
2. Rear parcel shelf finisher
3. Seatback release cover
4. Child anchor cover
5. Seatback latch cover
Removal and Installation
REMOVAL
1. Remove rear seat cushion. Refer to SE-25, "Removal and Installation"
2. Remove rear lower finis ...
Intelligent key system/engine start function symptoms
Symptom Table
Engine cannot be started with all Intelligent Keys.
CAUTION:
• Follow Trouble Diagnosis Flowchart referring to “SEC-10, "Work Flow"”.
Determine malfunctioning
condition before performing this diagnosis.
• Check that vehicle is under the condition shown in “ ...
Clearing the programmed information
The following procedure clears the programmed
information from both buttons. Individual buttons
cannot be cleared. However, individual buttons
can be reprogrammed. See “Reprogramming a
single HomeLink® button” in this section.
To clear all programming:
1. Press and hold the two outer Ho ...