Nissan Altima 2007-2012 Service Manual: B210C starter control relay
Description
Starter control relay, integrated in IPDM E/R, permits the starter relay operation when in N or P position and the steering is locked or unlocked. It is installed in parallel with the starter relay.
DTC Logic
DTC DETECTION LOGIC
NOTE: • If DTC B210C is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to SEC-433, "DTC Logic".
• If DTC B210C is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to SEC-434, "DTC Logic".
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn the power supply position to start under the following conditions and wait for at least 1 second.
- CVT selector lever is in the P or N position.
- Depress the brake pedal
2. Check “Self diagnostic result” with CONSULT-III.
Is DTC detected? YES >> Refer to SEC-446, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.INSPECTION START
1. Turn ignition switch ON.
2. Check “Self diagnostic result” with CONSULT-III.
3. Touch “ERASE”.
4. Perform DTC Confirmation Procedure.
Refer to PCS-45, "DTC Index".
Is the DTC B210C displayed again? YES >> Replace IPDM E/R. Refer to PCS-48, "Removal and Installation".
NO >> Inspection End.
B210B starter control relay
Description
Starter control relay, integrated in IPDM E/R, permits the starter relay
operation when in N or P position and
the steering is locked or unlocked. It is installed in parallel with the ...
B210D starter relay
Description
Located in IPDM E/R, it runs the starter motor. The starter relay is turned
ON by the BCM when the ignition
switch is in START position. IPDM E/R transmits the starter relay ON signal ...
Other materials:
The seat belt warning continues sounding, or does not
sound
Description
• Seat belt warning does not sound even though driver seat belt is not
fastened.
• Seat belt warning sounds even though driver seat belt is fastened.
Diagnosis Procedure
1. CHECK WARNING CHIME OPERATION
With the driver door open, turn lighting switch to 1st or 2nd position.
...
Corrosion protection
Description
To provide improved corrosion prevention, the following anti-corrosive
measures have been implemented in
NISSAN production plants. When repairing or replacing body panels, it is
necessary to use the same anti-corrosive
measures.
Anti-Corrosive Precoated Steel (Galvannealed Steel) ...
Ignition signal
Description
The ignition signal from the ECM is sent to and amplified by the power
transistor. The power transistor turns
ON and OFF the ignition coil primary circuit. This ON/OFF operation induces the
proper high voltage in the coil
secondary circuit.
Component Function Check
1.INSPECTION ...