Nissan Altima 2007-2012 Service Manual: Basic inspection

DIAGNOSIS AND REPAIR WORKFLOW

Interview Sheet

    Precaution
    Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER ...

    Function diagnosis
    CAN COMMUNICATION SYSTEM CAN System Specification Chart Determine CAN system type from the following specification chart. NOTE: Refer to LAN-16, "Trouble Diagnosis Procedure" for how ...

    Other materials:

    B210D starter relay
    Description Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B210D is display ...

    Camshaft valve clearance
    Camshaft valve clearance • Perform this inspection as follows after removal, installation, or replacement of the camshaft or any valverelated parts, or if there are any unusual engine conditions due to changes in valve clearance over time (starting, idling, and/or noise). 1. Warm up the ...

    BSW/LDW automatic deactivation
    When dirt, rain or snow cannot be removed by the automatic washer and blower and accumulates on the camera, making it impossible to detect the vehicles or the lane markers, the BSW and/or LDW system will be turned off automatically. The BSW light (white) and/or LDW light (white) will blink, ...