Nissan Altima 2007-2012 Service Manual: Battery saver

CONSULT-III Function

WORK SUPPORT

* : Initial setting

DATA MONITOR

ACTIVE TEST

* : Each lamp switch is in ON position.

    Comb SW
     CONSULT-III Function DATA MONITOR *: With autolamp system ...

    Diagnosis system (IPDM E/R)
    Diagnosis Description AUTO ACTIVE TEST Description In auto active test mode, the IPDM E/R sends a drive signal to the following systems to check their operation. • Oil pressure warning lamp ...

    Other materials:

    DLC branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the data link connector for damage, bend and loose connection (connector side and harness side) ...

    Reporting safety defects
    For USA If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTSA) in addition to notifying NISSAN. If NHTSA receives similar complaints, it may open an inv ...

    P2100, p2103 throttle control motor relay
    Description Power supply for the throttle control motor is provided to the ECM via throttle control motor relay. The throttle control motor relay is ON/OFF controlled by the ECM. When the ignition switch is turned ON, the ECM sends an ON signal to throttle control motor relay and battery vol ...