Nissan Altima 2007-2012 Service Manual: Function diagnosis
- Headlamp (xenon type)
- Headlamp (halogen type)
- Daytime running light system
- Auto light system
- Front fog lamp
- Turn signal and hazard warning lamps
- Parking, license plate and tail lamps
- Combination switch reading system
- Diagnosis system (BCM)
- Diagnosis system (IPDM E/R)
Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1.INTERVIEW FOR MALFUNCTION
Find out what the customer's concerns are.
>> GO TO 2
2.SYMPTOM CHECK
Verify the s ...
Headlamp (xenon type)
System Diagram
System Description
Control of the headlamp system is dependent upon the position of the lighting
switch (combination switch).
When the lighting switch is placed in the 2nd pos ...
Other materials:
P0643 sensor power supply
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always turn
ignition switch OFF and wait at
least 10 seconds before conducting the next test.
TESTING CONDITION:
Before performing the following proced ...
Front wiper ARMS
Removal and Installation
REMOVAL
1. Turn wiper switch ON to operate wiper motor, and then turn wiper switch
OFF (auto stop).
2. Open hood, remove arm caps, and remove wiper arm nuts.
3. Raise wiper arm, and remove wiper arm from the vehicle.
INSTALLATION
1. Clean up the pivot area as sho ...
Compression pressure
CHECKING COMPRESSION PRESSURE
1. Warm up the engine to full operating temperature.
2. Release the fuel pressure. Refer to EC-550, "Inspection" (California),
EC-1038, "Inspection" (Except California).
3. Remove the ignition coil and spark plug from each cylinder.
Refer ...