Nissan Altima 2007-2012 Service Manual: BCM (Body control module)

Removal and Installation

For removal and installation of the BCM refer to BCS-96, "Removal and Installation".

    Push button ignition switch
    Removal and Installation REMOVAL 1. Remove the cluster lid A assembly. Refer to IP-12, "Removal and Installation". 2. Release the pawls (A) and remove the push-button ignition switc ...

    Other materials:

    Multiport fuel injection system
    System Diagram System Description INPUT/OUTPUT SIGNAL CHART *1: This sensor is not used to control the engine system under normal conditions. *2: This signal is sent to the ECM through CAN communication line. *3: ECM determines the start signal status by the signals of engine speed and ...

    P1800 Vias control solenoid valve 1
    Description The VIAS control solenoid valve 1 cuts the intake manifold vacuum signal for power valve 1 control. It responds to ON/OFF signals from the ECM. When the solenoid is OFF, the vacuum signal from the intake manifold is cut. When the ECM sends an ON signal the coil pulls the plunger ...

    Service data and specifications (SDS)
    General Specification CAUTION: • Use only Genuine NISSAN CVT Fluid NS-2. Do not mix with other fluid. • Using CVT fluid other than Genuine NISSAN CVT Fluid NS-2 will deteriorate in driveability and CVT durability, and may damage the CVT, which is not covered by the NISSAN new vehicle l ...