Nissan Altima 2007-2012 Service Manual: Push button ignition switch
Removal and Installation
REMOVAL
1. Remove the cluster lid A assembly. Refer to IP-12, "Removal and Installation".
2. Release the pawls (A) and remove the push-button ignition switch (1) from cluster lid A.
INSTALLATION
Installation is in the reverse order of removal.
BCM (Body control module)
Removal and Installation For removal and installation of the BCM refer to BCS-96, "Removal and Installation". ...Charging system
...Other materials:
Mixture ratio self-learning value
clear
Description
This describes how to erase the mixture ratio self-learning value. For the
actual procedure, follow the instructions
in “Diagnosis Procedure”.
Special Repair Requirement
1.START
1. Start engine and warm it up to normal operating temperature.
2. Select “SELF-LEARNING CO ...
LATCH (Lower Anchors and Tethers for CHildren) System
LATCH system anchor locat
Your vehicle is equipped with special anchor
points that are used with LATCH (Lower Anchors
and Tethers for CHildren) system compatible
child restraints. This system may also be referred
to as the ISOFIX or ISOFIX compatible system.
With this system, you do not ha ...
U1001 Can comm circuit
Description
CAN (Controller Area Network) is a serial communication line for real time
application. It is an on-vehicle multiplex
communication line with high data communication speed and excellent error
detection ability. Many electronic
control units are equipped onto a vehicle, and each c ...