Nissan Altima 2007-2012 Service Manual: Camera control unit
Removal and Installation - Coupe
REMOVAL
1. Disconnect the negative battery terminal.
2. Remove the trunk floor carpet and spare tire cover. Refer to INT-23, "Removal and Installation".
3. Remove the LH trunk side finisher. Refer to INT-23, "Removal and Installation".
4. Remove the LH trunk floor spacer.
5. Disconnect the rear view camera control unit connector (A), then remove the rear view camera control unit screws (B) and remove the rear view camera control unit (1).
INSTALLATION
Installation is in the reverse order of removal.
Removal and Installation - Sedan
REMOVAL
1. Disconnect the negative battery terminal.
2. Remove the trunk side finisher. Refer to INT-46, "Removal and Installation".
3. Disconnect the rear view camera control unit connector (A), then remove the rear view camera control unit screws (B) and remove the rear view camera control unit (1).
INSTALLATION
Installation is in the reverse order of removal.
Rear view camera
Removal and Installation
REMOVAL
1. Remove the license plate finisher. Refer to EXT-23, "Removal and
Installation" (coupe) and EXT-46,
"Removal and Installation" (sedan).
...
Cruise control system QR25DE for california
FUNCTION DIAGNOSIS
AUTOMATIC SPEED CONTROL DEVICE
(ASCD)
Description
For information regarding the ASCD system, refer to EC-67, "System
Description" . ...
Other materials:
Power supply and ground circuit
Diagnosis Procedure
1.CHECK GROUND CONNECTION
1. Turn ignition switch OFF.
2. Check ground connection E9. Refer to Ground Inspection in GI-45, "Circuit
Inspection".
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair or replace ground connection.
2.CHE ...
Malfunction indicator lamp
Description
The Malfunction Indicator Lamp (MIL) is located on the combination
meter.
The MIL will illuminate when the ignition switch is turned ON without
the engine running. This is a bulb check.
When the engine is started, the MIL should turn off. If the MIL
remains illuminated, the on ...
Basic inspection
COMPONENT INSPECTION
Inspection
AFTER A COLLISION
WARNING:
Inspect all seat belt assemblies including retractors and attaching hardware
after any collision.
NISSAN/INFINITI recommends that all seat belt assemblies in use during a
collision be replaced
unless the collision was minor and t ...