Nissan Altima 2007-2012 Service Manual: Rear view camera

Removal and Installation

REMOVAL

1. Remove the license plate finisher. Refer to EXT-23, "Removal and Installation" (coupe) and EXT-46, "Removal and Installation" (sedan).

2. Remove trunk lid finisher. Refer to INT-22, "Exploded View".

3. Remove the rear view camera by performing the following: • For coupe models, release the clip (A), then pull out the rear view camera connector, disconnect the rear view camera connector, press the rear view camera tab (B) and remove the rear view camera (1).

• For sedan models, disconnect the rear view camera connector (B), press the rear view camera tab (A) and remove the rear view camera (1).

INSTALLATION

Installation is in the reverse order of removal.

Adjustment

REAR VIEW MONITOR

For adjustment on the rear view camera, refer to AV-238, "REAR VIEW MONITOR GUIDING LINE ADJUSTMENT : Special Repair Requirement".

    Microphone
    Removal and Installation REMOVAL 1. Remove the room/map lamp assembly. Refer to INL-121, "Removal and Installation". 2. Detach the microphone connector (A). 3. Remove the map lamp ...

    Camera control unit
    Removal and Installation - Coupe REMOVAL 1. Disconnect the negative battery terminal. 2. Remove the trunk floor carpet and spare tire cover. Refer to INT-23, "Removal and Installation&quo ...

    Other materials:

    Fender protector
    Removal and Installation 1. Fender protector 2. Fender protector side cover A. J-clips B. Clips C. Center mudguard screw a. Sheet metal nut REMOVAL 1. Remove the engine under cover. Refer to EXT-34, "Removal and Installation". 2. Remove the screw from center mudguard. 3 ...

    B2609 steering status
    Description There are 2 switches in the electronic steering column lock (steering lock/unlock switch 1 and 2). BCM compares those two switches conditions to judge the present steering status. DTC Logic DTC DETECTION LOGIC NOTE: • If DTC B2609 is displayed with DTC U1000, first perform the ...

    Power generation voltage variable control system operation inspection
    Inspection Procedure CAUTION: When performing this inspection, always use a charged battery that has completed the battery inspection. (When the charging rate of the battery is low, the response speed of the voltage change will become slow. This can cause an incorrect inspection.) 1.CHECK ...