Nissan Altima 2007-2012 Service Manual: Can communication circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CONNECTOR INSPECTION
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Disconnect all the unit connectors on CAN communication system.
4. Check terminals and connectors for damage, bend and loose connection.
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair the terminal and connector.
2.CHECK HARNESS CONTINUITY (SHORT CIRCUIT)
Check the continuity between the data link connector terminals.
Is the inspection result normal? YES >> GO TO 3.
NO >> Check the harness and repair the root cause.
3.CHECK HARNESS CONTINUITY (SHORT CIRCUIT)
Check the continuity between the data link connector and the ground.
Is the inspection result normal? YES >> GO TO 4.
NO >> Check the harness and repair the root cause.
4.CHECK ECM AND IPDM E/R TERMINATION CIRCUIT
1. Remove the ECM and the IPDM E/R.
2. Check the resistance between the ECM terminals.
3. Check the resistance between the IPDM E/R terminals.
Is the measurement value within the specification? YES >> GO TO 5.
NO >> Replace the ECM and/or the IPDM E/R.
5.CHECK SYMPTOM
Connect all the connectors. Check if the symptoms described in the “Symptom (Results from interview with customer)” are reproduced.
Inspection result Reproduced>>GO TO 6.
Non-reproduced>>Start the diagnosis again. Follow the trouble diagnosis procedure when past error is detected.
6.CHECK UNIT REPRODUCTION
Perform the reproduction test as per the following procedure for each unit.
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Disconnect one of the unit connectors of CAN communication system.
NOTE: ECM and IPDM E/R have a termination circuit. Check other units first.
4. Connect the battery cable to the negative terminal. Check if the symptoms described in the “Symptom (Results from interview with customer)” are reproduced.
NOTE: Although unit-related error symptoms occur, do not confuse them with other symptoms.
Inspection result
Reproduced>>Connect the connector. Check other units as per the above procedure.
Non-reproduced>>Replace the unit whose connector was disconnected.
IPDM-E branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors ...
Lan system can system (type 1)
COMPONENT DIAGNOSIS ...
Other materials:
Power consumption control system
System Diagram
System Description
OUTLINE
• BCM incorporates a power saving control function that reduces the power
consumption according to the
vehicle status.
• BCM switches the status (control mode) by itself with the power saving control
function. It performs the sleep
request ...
Exhaust manifold and three way
catalyst
Removal and Installation
1. Exhaust manifold cover (upper)
2. Exhaust manifold stay
3. Manifold yoke (type B)
4. Manifold yoke (type A)
5. Exhaust manifold cover (lower)
6.. Exhaust manifold and three way catalyst
assembly
7. Exhaust manifold gasket
8. Air fuel ratio (A/F) sensor 1
...
Can communication system
Component Parts Location
1. ABS actuator and electric unit (control
unit) E26
2. AV control unit M46
3. TCM F16
4. ECM E10
5. IPDM E/R E17
6. BCM M19
7. Combination meter M24
8. Steering angle sensor M53
9. Air bag diagnosis sensor unit M35
10. Data link connector M22
Wiring Diagram - ...