Nissan Altima 2007-2012 Service Manual: Center ventilator grilles

 Removal and Installation

REMOVAL

Remove the center ventilator grilles (1) from the instrument panel using a suitable tool.

INSTALLATION

Installation is in the reverse order of removal.

    Ducts, nozzles and grilles
    Components 1. Upper ventilator duct 2. Heater and cooling unit assembly 3. Connector duct (LH 4. Floor ventilator duct (LH) 5. Connector duct (center) 6. Rear floor duct (LH) 7. Rear ventilat ...

    Side ventilator grilles
     Removal and Installation REMOVAL Release the tabs and then remove the side ventilator grilles using a suitable tool. CAUTION: Use a suitable tool to remove the grille to avoid damage to ...

    Other materials:

    Evap leak check
    Inspection CAUTION: • Do not use compressed air or a high pressure pump. • Do not exceed 4.12 kPa (0.042 kg/cm2, 0.6 psi) of pressure in EVAP system. NOTE: • Do not start engine. • Improper installation of EVAP service port adapter [commercial service tool: (J-41413-OBD)] to th ...

    Malfunction indicator lamp
    Description The Malfunction Indicator Lamp (MIL) is located on the combination meter. The MIL will light up when the ignition switch is turned ON without the engine running. This is a bulb check. When the engine is started, the MIL should go off. If the MIL remains on, the on board diagno ...

    P1722 Estm vehicle speed signal
    Description The vehicle speed signal is transmitted from ABS actuator and electric unit (control unit) to TCM by CAN communication line. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION PROCEDURE” has ...