Nissan Altima (L32) 2007-2012 Service Manual: Combination meter
Diagnosis Procedure
1.CHECK FUSES
Check for blown combination meter fuses.
Is the inspection result normal?
YES >> GO TO 2
NO >> If fuse is blown, be sure to eliminate cause of malfunction before
installing new fuse.
2.POWER SUPPLY CIRCUIT CHECK
1. Disconnect combination meter connector.
2. Check voltage between combination meter harness connector
M24 terminals 1, 2, 14 and ground.
Is the inspection result normal?
YES >> GO TO 3
NO >> Check harness for open between combination meter and fuse.
3.GROUND CIRCUIT CHECK
1. Turn ignition switch OFF.
2. Check continuity between combination meter harness connector
terminals 3, 4, 23 and ground.
Is the inspection result normal?
YES >> Inspection End.
NO >> Check ground harness.
Diagnosis Procedure
1. CHECK FUSE AND FUSIBLE LINK
Check if the following BCM fuse or fusible link are blown.
Is the fuse or fusible link blown?
YES >> Replace the blown fuse or fusible l ...
Other materials: Vehicle information display warnings
and indicators
The following messages may appear in
your vehicle information display.
Engine start operation for
Intelligent Key system (if
I-Key battery level is low)
This indicator appears when the battery of
the Intelligent Key is low and when the Intelligent
Key system and the vehicle are not
communicating no ...
All-Wheel Drive (AWD) (if so equipped)
If any malfunction occurs in the AWD system
while the engine is running, messages
are displayed in the meter.
If the AWD error warning message is displayed,
there may be a malfunction in the
AWD system. Reduce vehicle speed and
have your vehicle checked. It is recommended
that you visit a NISSAN de ...
Wiper and washer switch
Switch operation
WARNING
In freezing temperatures the washer
solution may freeze on the windshield
and obscure your vision which may
lead to an accident. Warm the windshield
with the defroster before you
wash the windshield.
CAUTION
Do not operate the washer continuously
for more than 30 seconds ...
Power supply and ground circuit
BCM (Body control module)