Nissan Altima 2007-2012 Service Manual: Component diagnosis

Diagnosis system (IPDM E/R)
Diagnosis Description AUTO ACTIVE TEST Description In auto active test mode, the IPDM E/R sends a drive signal to the following systems to check their operation. • Oil pressure warning lamp ...

U1000 can comm circuit
Description Refer to LAN-7, "System Description". DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE Diagnosis Procedure 1. PERFORM SELF DIAGNOSTIC 1. Turn ignition switch ON ...

Other materials:

P2138 APP sensor
Description The accelerator pedal position sensor is installed on the upper end of the accelerator pedal assembly. The sensor detects the accelerator position and sends a signal to the ECM. Accelerator pedal position sensor has two sensors. These sensors are a kind of potentiometers which tra ...

P0703 stop lamp switch
Description BCM detects ON/OFF state of the stop lamp switch and transmits the data to the TCM via CAN communication by converting the data to a signal. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a safe speed. NOTE: If “DTC CONFIRMATION ...

Can communication circuit
Diagnosis Procedure INSPECTION PROCEDURE 1.CONNECTOR INSPECTION 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Disconnect all the unit connectors on CAN communication system. 4. Check terminals and connectors for damage, bend and loose con ...