Nissan Altima 2007-2012 Service Manual: Component diagnosis
- Power supply routing circuit
- Ground
- Electrical units location
- Standardized relay
- Fuse block - junction box (J/B)
- Fuse, fusible link and relay box
- IPDM E/R (Intelligent power distribution module engine room)
Inspection and adjustment
ADDITIONAL SERVICE WHEN REMOVING BATTERY
NEGATIVE TERMINAL
Special Repair Requirement
Required Procedure After Battery Disconnection
...
Power supply routing circuit
Wiring Diagram — Battery Power Supply —
Wiring Diagram — Accessory Power Supply —
Wiring Diagram — Ignition Power Supply —
Fuse
• If fuse is ...
Other materials:
Stall test
Inspection and Judgment
INSPECTION
1. Inspect the amount of engine oil. Replenish the engine oil if necessary.
2. Drive for about 10 minutes to warm up the vehicle so that the
CVT fluid temperature is 50 to 80°C (122 to 176°F). Inspect the
amount of CVT fluid. Replenish if necessary.
3. ...
STRG branch line circuit
Diagnosis Procedure
INSPECTION PROCEDURE
1.CHECK CONNECTOR
1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the terminals and connectors of the steering angle sensor for damage,
bend and loose connection
(unit side and connector side) ...
Automatic speed control device
(ASCD)
System Diagram
System Description
INPUT/OUTPUT SIGNAL CHART
*: This signal is sent to the ECM through CAN communication line
BASIC ASCD SYSTEM
Refer to Owner's Manual for ASCD operating instructions.
Automatic Speed Control Device (ASCD) allows a driver to keep vehicle at
predetermin ...