Nissan Altima 2007-2012 Service Manual: Diagnosis system (meter)
Diagnosis Description
SELF-DIAGNOSIS MODE
• Odo/trip meter and information display segment operation can be checked in self-diagnosis mode.
• Meters/gauges can be checked in self-diagnosis mode.
OPERATION PROCEDURE
1. Turn the ignition switch OFF.
2. While pushing the odo/trip meter switch, turn the ignition switch ON again.
3. Push the odo/trip meter switch at least 3 times within 7 seconds after the ignition switch is turned ON.
4. The unified meter control unit is turned to self-diagnosis mode.
• All the segments on the odo/trip meter illuminate.
• Dots in all segments of information display LCD (1) flash alternately.
NOTE: If any of the segments are not displayed, replace the combination meter. Refer to MWI-176, "Removal and Installation".
5. Push the odo/trip meter switch. Each meter/gauge should indicate as shown in the figure.
CONSULT-III Function (METER/M&A)
CONSULT-III can display each diagnostic item using the diagnostic test modes shown following.
SELF-DIAG RESULTS
Display Item List
Refer to MWI-95, "DTC Index".
DATA MONITOR
Display Item List
NOTE: Some items are not available due to vehicle specification.
*: The monitor will indicate “OFF” even though the brake warning lamp is on if either of the following conditions exist.
• The parking brake is engaged
• The brake fluid level is low
Parking brake release warning chime
System Diagram
System Description
DESCRIPTION
• The combination meter receives the vehicle speed signal from the ABS
actuator and electric unit (control
unit) via CAN communication l ...
Diagnosis system (BCM)
BUZZER
CONSULT-III Function
CONSULT-III APPLICATION ITEMS
DATA MONITOR
ACTIVE TEST
...
Other materials:
Air cleaner filter
Removal and Installation
1. Air duct hose
2. Air cleaner filter
3. Air cleaner case (front)
4. Front air duct
5. Air cleaner mounting bracket
6. Air cleaner case (rear)
7. Mass air flow sensor
A. To electric throttle control actuator
B. Air cleaner case side clips
CHANGING THE AIR CLEANE ...
Rear window glass
Components - Sedan
1. Rear window glass
2. Spacer
3. Adhesive
4. Roof panel outer
5. Rear window molding
6. Body side outer
7. Parcel shelf
8. Primer
D. 7 (0.28)
E. 12 (0.47)
F. 12.5 (0.49)
G. 16 (0.63)
Components - Coupe
1. Rear window glass
2. Spacer
3. Adhesive
4. Roof panel ...
B210E starter relay
Description
Located in IPDM E/R, it runs the starter motor. The starter relay is turned
ON by the BCM when the ignition
switch is in START position. IPDM E/R transmits the starter relay ON signal to
BCM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
• If DTC B210E is displa ...