Nissan Altima 2007-2012 Service Manual: Disassembly and assembly

Side window glass
Components 1. Windshield glass 2. Spacer 3. Seal 4. Body side outer 5. Primer 6. Adhesive 7. Encapsulation E. 7(0.28) F. 12 (0.47) G. 15 (0.59) Removal and Installation REMOVAL 1. Remov ...

Front regulator
Exploded View 1. Door 2. Inside seal 3. Door glass 4. Regulator assembly 5. Door module assembly 6. Window motor Disassembly Remove the window motor nuts (A) the four window regulator bolts ...

Other materials:

P0744 A/T TCC S/V function (lock -up)
Description This malfunction is detected when the torque converter clutch does not lock-up as instructed by the TCM. This is not only caused by electrical malfunction (circuits open or shorted), but also by mechanical malfunction such as control valve sticking, improper solenoid valve operat ...

Body sealing
Description The following figure shows the areas which are sealed at the factory. Sealant which has been applied to these areas should be smooth and free from cuts or gaps. Care should be taken not to apply an excess amount of sealant and not to allow other unaffected parts to come into conta ...

Drip molding
Removal and Installation REMOVAL 1. Using a trim stick or equivalent, disconnect the drip mouldings starting at the front, working rearward. 2. Remove the drip moldings. INSTALLATION Installation is in the reverse order of removal. • Insert drip moldings onto vehicle starting at t ...