Nissan Altima 2007-2012 Service Manual: Drip molding

Removal and Installation



1. Using a trim stick or equivalent, disconnect the drip mouldings starting at the front, working rearward.

2. Remove the drip moldings.


Installation is in the reverse order of removal.

• Insert drip moldings onto vehicle starting at the rear, working forward.

    Door outside molding
    Removal and Installation 1. Front door outside molding 2. Rear door outside molding Front Door Outside Molding Removal 1. Open the front door window fully. 2. Remove the side view mirror. ...

    Roof side molding
    Removal and Installation 1. Body side outer panel 2. Windshield 2. Windshield REMOVAL 1. Lift and twist the roof side molding up from the rear edge. 2. Disconnect the roof side molding ...

    Other materials:

    Insufficient cooling
    Component Function Check SYMPTOM: Insufficient cooling INSPECTION FLOW 1. CONFIRM SYMPTOM BY PERFORMING OPERATION CHECK - TEMPERATURE DECREASE 1. Press the AUTO switch. 2. Turn temperature control dial (LH) counterclockwise until 18В°C (32В°F) is displayed. 3. Check for cold air at d ...

    When the doors are locked using one of the following methods, the doors can not be opened using the inside or outside door handles. The doors must be unlocked to open the doors. WARNING ● Always have the doors locked while driving. Along with the use of seat belts, this provides greater ...

    On-vehicle maintenance
    REAR SUSPENSION ASSEMBLY On-vehicle Service • Check the suspension parts for excessive play, cracks, wear or damage. Shake each rear wheel to check for excessive play. • Retighten all nuts and bolts to the specified torque. • Make sure that the cotter pin is installed. ...