Nissan Altima 2007-2012 Service Manual: Front fog lamp
Aiming Adjustment
The fog lamp is a semi-sealed beam type which uses a replaceable halogen bulb. Before performing aiming adjustment, make sure of the following.
• Keep all tires inflated to correct pressure.
• Place vehicle on level ground.
• See that vehicle is unloaded (except for full levels of coolant, engine oil and fuel, and spare tire, jack, and tools). Have the driver or equivalent weight placed in driver seat.
• Adjust aiming in the vertical direction by turning the adjusting screw (A).
• When performing adjustment, if necessary, cover the headlamps and opposite fog lamp.
1. Set the distance between the screen and the center of the fog lamp lens as shown.
2. Turn front fog lamps ON.
3. Adjust front fog lamps using adjusting screw so that the top edge of the high intensity zone is 100 mm (4 in) below the height of the fog lamp centers as shown.
Headlamp
Aiming Adjustment
PREPARATION BEFORE ADJUSTING
NOTE:
• For details, refer to the regulations in your area.
• Perform aiming adjustment if the vehicle front body has been repaired and/or
t ...
Other materials:
Front wiper blade
Removal and Installation
REMOVAL
1. Lift the front wiper arm and wiper blade assembly away from the
windshield.
2. Rotate the front wiper blade assembly and push the release tab
(A), then move the front wiper blade assembly down (B) the
front wiper arm.
3. Remove the front wiper blade as ...
Manual control
While using the Voice Recognition system, it is
possible to select menu options by using the
steering wheel controls instead of speaking voice
commands. The manual control mode does not
allow dialing a phone number by digits. The user
may select an entry from the Phonebook or Recent
Calls list ...
Engine control system
System Diagram
System Description
ECM performs various controls such as fuel injection control and ignition
timing control.
Component Parts Location
1. Intake valve timing control solenoid
valve
2. Ignition coil (with power transistor)
and spark plug
3. Knock sensor,
Crankshaft posi ...