Nissan Altima 2007-2012 Service Manual: On-vehicle repair
- Headlamp
- Front fog lamp
- Stop lamp
- Back-up lamp
- License plate lamp
- Rear combination lamp
- Lighting and turn signal switch
- Hazard switch
Front fog lamp
Aiming Adjustment
The fog lamp is a semi-sealed beam type which uses a replaceable halogen
bulb. Before performing aiming
adjustment, make sure of the following.
• Keep all tires inflated to ...
Headlamp
Bulb Replacement
HEADLAMP
CAUTION:
• Do not touch the glass of bulb directly by hand. Keep grease and other oily
substances away from
bulb. Do not touch bulb by hand while it is lit or right a ...
Other materials:
P0453 evap control system pressure
sensor
Description
The EVAP control system pressure sensor detects pressure in the
purge line. The sensor output voltage to the ECM increases as pressure
increases.
DTC Logic
DTC DETECTION LOGIC
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously cond ...
P1226 TP Sensor
Description
Electric throttle control actuator consists of throttle control motor,
throttle position sensor, etc. The throttle position sensor responds to
the throttle valve movement.
The throttle position sensor has two sensors. These sensors are a
kind of potentiometer which transform the t ...
Additional service when replacing
control unit
Description
When replacing ECM, the following procedure must be performed.
Special Repair Requirement
1.PERFORM INITIALIZATION OF NVIS (NATS) SYSTEM AND REGISTRATION OF ALL
NVIS (NATS) IGNITION
KEY IDS
Refer to SEC-15, "ECM RE-COMMUNICATING FUNCTION : Special Repair Requireme ...