Other materials:

Air mix door motor
Removal and Installation AIR MIX DOOR MOTOR - LH Removal 1. Remove the instrument lower cover LH. Refer to IP-12, "Removal and Installation". 2. Remove the center console side finisher LH. Refer to IP-12, "Removal and Installation". 3. Remove the heater and cooling ...

Power supply and ground circuit
Diagnosis Procedure 1.INSPECTION START Start engine. Is engine running? YES >> GO TO 8. NO >> GO TO 2. 2.CHECK ECM POWER SUPPLY CIRCUIT-I 1. Turn ignition switch OFF and then ON. 2. Check the voltage between ECM harness connector and ground. Is the inspection result n ...

P2127, P2128 APP Sensor
Description The accelerator pedal position sensor is installed on the upper end of the accelerator pedal assembly. The sensor detects the accelerator position and sends a signal to the ECM. Accelerator pedal position sensor has two sensors. These sensors are a kind of potentiometer which tran ...