Nissan Altima 2007-2012 Service Manual: Front tweeter

Removal and Installation

REMOVAL

1. Remove the front pillar finisher. Refer to INT-20, "Removal and Installation" (coupe) and INT-42, "Removal and Installation" (sedan).

2. Remove tweeter speaker grille. Refer to IP-12, "Removal and Installation".

3. Remove the tweeter speaker screws (A), disconnect the tweeter speaker connector and remove the tweeter speaker (1).

INSTALLATION

Installation is in the reverse order of removal.

    Bose speaker AMP
    Removal and Installation - Coupe REMOVAL 1. Disconnect the negative battery terminal. 2. Remove the trunk floor carpet and spare tire cover. Refer to INT-23, "Removal and Installation&quo ...

    Center speaker
    Removal and Installation REMOVAL 1. Remove the center speaker grille. Refer to IP-12, "Removal and Installation". 2. Remove the center speaker screws (A), then pull out the center s ...

    Other materials:

    Refrigerant pressure sensor
    Description The refrigerant pressure sensor is installed at the condenser of the air conditioner system. The sensor uses an electrostatic volume pressure transducer to convert refrigerant pressure to voltage. The voltage signal is sent to ECM, and ECM controls cooling fan system. Component ...

    P1551, P1552 Battery current sensor
    Description The power generation voltage variable control enables fuel consumption to be decreased by reducing the engine load which is caused by the power generation of the generator. The battery current sensor is installed to the battery cable at the negative terminal. The sensor measures ...

    AV Branch line circuit
    Diagnosis Procedure INSPECTION PROCEDURE 1.CHECK CONNECTOR 1. Turn the ignition switch OFF. 2. Disconnect the battery cable from the negative terminal. 3. Check the terminals and connectors of the AV control unit for damage, bend and loose connection (unit side and connector side). I ...