Nissan Altima 2007-2012 Service Manual: Center speaker

Removal and Installation

REMOVAL

1. Remove the center speaker grille. Refer to IP-12, "Removal and Installation".

2. Remove the center speaker screws (A), then pull out the center speaker (1), then disconnect the center speaker connector and remove the center speaker (1).

INSTALLATION

Installation is in the reverse order of removal.

    Front tweeter
    Removal and Installation REMOVAL 1. Remove the front pillar finisher. Refer to INT-20, "Removal and Installation" (coupe) and INT-42, "Removal and Installation" (sedan). 2 ...

    Front door speaker
    Removal and Installation REMOVAL 1. Remove the front door finisher. Refer to INT-12, "Removal and Installation" (coupe) and INT-34, "Removal and Installation" (sedan). 2. R ...

    Other materials:

    Tachometer
     System Diagram System Description The tachometer indicates engine speed in revolutions per minute (rpm). The ECM provides an engine speed signal to the combination meter via CAN communication lines. Component Parts Location 1. Combination meter M24 2. IPDM E/R E17, E18, E201, ...

    IPDM E/R (Intelligent power distribution module engine room)
    Reference Value VALUES ON THE DIAGNOSIS TOOL TERMINAL LAYOUT PHYSICAL VALUES Wiring Diagram — Sedan Fail Safe CAN COMMUNICATION CONTROL When CAN communication with ECM and BCM is impossible, IPDM E/R performs fail-safe control. After CAN communication recov ...

    POWER STEERING OIL PUMP
    Inspection RELIEF OIL PRESSURE CAUTION: Make sure that belt tension is normal before starting the following procedure. 1. Connect the Tool between oil pump discharge connector and high-pressure hose. Bleed air from the hydraulic circuit while opening valve fully. Refer to ST-8, "Inspectio ...