Nissan Altima (L32) 2007-2012 Service Manual: Front tweeter (coupe)
Description
The audio unit sends audio signals to the front tweeters using the door
speaker circuits.
Diagnosis Procedure
1.HARNESS CHECK
1. Disconnect audio unit connector M43 (A) and suspect tweeter
connector (B).
2. Check continuity between audio unit harness connector M43 (A)
and suspect tweeter harness connector (B).
3. Check continuity between audio unit harness connector M43 (A)
and ground.
Are the continuity results as specified?
YES >> GO TO 2
NO >> • Check connector housings for disconnected or loose terminals.
• Repair harness or connector.
2.FRONT TWEETER SIGNAL CHECK
1. Connect audio unit connector and tweeter connector.
2. Turn ignition switch to ACC.
3. Push “POWER” switch.
4. Check the signal between audio unit harness connector terminals
with CONSULT-III or oscilloscope.
Is the audio signal voltage as specified?
YES >> Replace tweeter. Refer to AV-73, "Removal and Installation".
NO >> Replace audio unit. Refer to AV-72, "Removal and
Installation".
Description
The audio unit sends audio signals to the front door speakers using the
door speaker circuits.
Diagnosis Procedure
1.HARNESS CHECK
1. Disconnect audio unit connector M43 (A) and su ...
Description
The audio unit sends audio signals to the tweeters using the door speaker
circuits.
Diagnosis Procedure
1.HARNESS CHECK
1. Disconnect audio unit connector M43 (A) and suspect tweete ...
Other materials: Seat belt extenders
If, because of body size or driving position, it
is not possible to properly fit the lap/
shoulder belt and fasten it, an extender
that is compatible with the installed seat
belts is available for purchase. The extender
adds approximately 8 in (200 mm)
of length and may be used for either the
driver ...
Settings
The setting mode allows you to change the
information displayed in the vehicle information
display. It also allows you to change
vehicle functions:
VDC
Driver Assistance
Clock
Meter Settings
Vehicle Settings
Maintenance
Alarm
Tire Pressures
Unit
Language
Factory Reset
VDC
The VDC Settin ...
System temporarily unavailable
Condition A:
The warning and assist functions of the I-LI
system are not designed to work under the
following conditions:
When you operate the lane change signal
and change the traveling lanes in the direction
of the signal. (The I-LI system
will be deactivated for approximately 2
seconds afte ...