Nissan Altima 2007-2012 Service Manual: Front tweeter (coupe)

Description

The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker amp. amplifies the audio signals before sending them to the front tweeters using the audio signal circuits.

Diagnosis Procedure

1.HARNESS CHECK

1. Disconnect BOSE speaker amp. connector B122 and suspect tweeter connector.

2. Check continuity between BOSE speaker amp. harness connector B122 (A) and suspect tweeter harness connector (B).

3. Check continuity between BOSE speaker amp. harness connector B122 (A) and ground.

Are continuity test results as specified? YES >> GO TO 2

NO >> • Check connector housings for disconnected or loose terminals.

• Repair harness or connector.

2.FRONT TWEETER SIGNAL CHECK

1. Connect BOSE speaker amp. connector B122 and suspect tweeter connector.

2. Turn ignition switch to ACC.

3. Push “POWER” switch.

4. Check the signal between BOSE speaker amp. harness connector B122 terminals with CONSULT-III or oscilloscope.

Are voltage readings as specified? YES >> Replace suspect tweeter. Refer to AV-440, "Removal and Installation".

NO >> GO TO 3

3.HARNESS CHECK

1. Disconnect AV control unit connector M47 and BOSE speaker amp. connector B121.

2. Check continuity between AV control unit harness connector (A) M47 and BOSE speaker amp. harness connector B121 (B).

3. Check continuity between AV control unit harness connector B121 (A) and ground.

Are continuity test results as specified? YES >> GO TO 4

NO >> • Check connector housings for disconnected or loose terminals.

• Repair harness or connector.

4.FRONT TWEETER SIGNAL CHECK

1. Connect AV control unit connector and BOSE speaker amp.

connector.

2. Turn ignition switch to ACC.

3. Push “POWER” switch.

4. Check the signal between AV control unit harness connector terminals with CONSULT-III or oscilloscope.

Are voltage readings as specified? YES >> Replace BOSE speaker amp. Refer to AV-438, "Removal and Installation - Coupe".

NO >> Replace AV control unit. Refer to AV-437, "Removal and Installation".

    Front door speaker (sedan)
    Description The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker amp. amplifies the audio signals before sending them to the front door speakers using the audio signal c ...

    Tweeter (sedan)
    Description The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker amp. amplifies the audio signals before sending them to the tweeters using the audio signal circuits. Dia ...

    Other materials:

    Function diagnosis
    NOISE, VIBRATION, AND HARSHNESS (NVH) TROUBLESHOOTING NVH Troubleshooting - Engine Noise Use the Chart Below to Help You Find the Cause of the Symptom 1. Locate the area where noise occurs. 2. Confirm the type of noise. 3. Specify the operating condition of engine. 4. Check specified ...

    Fuel pump
    Description *: ECM determines the start signal status by the signals of engine speed and battery voltage. The ECM activates the fuel pump for several seconds after the ignition switch is turned ON to improve engine start ability. If the ECM receives a engine speed signal from the camshaf ...

    Diagnosis and repair workflow
    Work Flow DETAILED FLOW 1.LISTEN TO CUSTOMER COMPLAINT Listen to customer complaint. Get detailed information about the conditions and environment when the symptom occurs. >> GO TO 2 2.VERIFY THE SYMPTOM WITH OPERATIONAL CHECK Verify the symptom with operational check. Refer to HAC- ...