Nissan Altima 2007-2012 Service Manual: Tweeter (sedan)

Description

The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker amp. amplifies the audio signals before sending them to the tweeters using the audio signal circuits.

Diagnosis Procedure

1.HARNESS CHECK

1. Disconnect BOSE speaker amp. connector B122 and suspect tweeter connector.

2. Check continuity between BOSE speaker amp. harness connector B122 (A) and suspect tweeter harness connector (B).

3. Check continuity between BOSE speaker amp. harness connector B122 (A) and ground.

Are continuity test results as specified? YES >> GO TO 2

NO >> • Check connector housings for disconnected or loose terminals.

• Repair harness or connector.

2.TWEETER SIGNAL CHECK

1. Connect BOSE speaker amp. connector B122 and suspect tweeter connector.

2. Turn ignition switch to ACC.

3. Push “POWER” switch.

4. Check the signal between BOSE speaker amp. harness connector B122 terminals with CONSULT-III or oscilloscope.

Are voltage readings as specified? YES >> Replace suspect tweeter. Refer to AV-440, "Removal and Installation".

NO >> GO TO 3

3.HARNESS CHECK

1. Disconnect AV control unit connector M47 and BOSE speaker amp. connector B121.

2. Check continuity between AV control unit harness connector (A) M47 and BOSE speaker amp. harness connector B121 (B).

3. Check continuity between AV control unit harness connector B121 (A) and ground.

Are continuity test results as specified? YES >> GO TO 4

NO >> • Check connector housings for disconnected or loose terminals.

• Repair harness or connector.

4.TWEETER SIGNAL CHECK

1. Connect AV control unit connector and BOSE speaker amp.

connector.

2. Turn ignition switch to ACC.

3. Push “POWER” switch.

4. Check the signal between AV control unit harness connector terminals with CONSULT-III or oscilloscope.

Are voltage readings as specified? YES >> Replace BOSE speaker amp. Refer to AV-438, "Removal and Installation - Sedan".

NO >> Replace AV control unit. Refer to AV-437, "Removal and Installation".

    Front tweeter (coupe)
    Description The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker amp. amplifies the audio signals before sending them to the front tweeters using the audio signal circuit ...

    Center speaker
    Description The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker amp. amplifies the audio signals before sending them to the center speaker using the audio signal circuit ...

    Other materials:

    On-vehicle repair
    EVAP CANISTER Exploded View Removal and Installation REMOVAL 1. Lift up the vehicle. 2. Remove EVAP canister fixing bolt. 3. Remove EVAP canister. NOTE: The EVAP canister vent control valve and EVAP canister system pressure sensor can be removed without removing the EVAP caniste ...

    Xenon headlights (if so equipped)
    WARNING HIGH VOLTAGE ● When xenon headlights are on, they produce a high voltage. To prevent an electric shock, never attempt to modify or disassemble. Always have your xenon headlights replaced at a NISSAN dealer. ● Xenon headlights provide considerably more light than conventi ...

    P0746 pressure control solenoid a performance (line pressure solenoid valve)
    Description The pressure control solenoid valve A (line pressure solenoid valve) regulates the oil pump discharge pressure to suit the driving condition in response to a signal sent from the TCM. DTC Logic DTC DETECTION LOGIC DTC CONFIRMATION PROCEDURE CAUTION: Always drive vehicle at a ...