Nissan Altima 2007-2012 Service Manual: Front wiper blade
Removal and Installation
REMOVAL
1. Lift the front wiper arm and wiper blade assembly away from the windshield.
2. Rotate the front wiper blade assembly and push the release tab (A), then move the front wiper blade assembly down (B) the front wiper arm.
3. Remove the front wiper blade assembly.
INSTALLATION
CAUTION: • After the front wiper blade assembly installation, return the front wiper arm to the original position on the windshield to prevent damage when the hood is opened.
• Check that the front wiper blade assembly contacts the windshield properly; otherwise the front wiper arm may be damaged from wind pressure while driving.
1. Insert the front wiper blade assembly onto the front wiper arm and slide it up until it clicks into place.
2. Rotate the front wiper blade assembly so the dimple is in the groove.
3. Lay the front wiper arm and front wiper blade assembly back down on the windshield.
Front wiper blade refill
Removal and Installation
REMOVAL
1. Remove the front wiper blade. Refer to WW-115, "FRONT WIPER BLADE :
Removal and Installation".
2. Hold the wiper blade refill lip at the end ( ...
Front wiper ARMS
Removal and Installation
REMOVAL
1. Turn wiper switch ON to operate wiper motor, and then turn wiper switch
OFF (auto stop).
2. Open hood, remove arm caps, and remove wiper arm nuts.
3. Rais ...
Other materials:
Seat belt, buckles, retractors, anchors
and adjusters
Inspection
CAUTION:
• After any collision, inspect all seat belt assemblies, including retractors
and other attached hardwares
(I.e. anchor bolt, guide rail set). Nissan recommends to replace all seat belt
assemblies in use
during a collision, unless not damaged and properly operating afte ...
Power window system
System Diagram
FRONT POWER WINDOW LH ANTI-PINCH SYSTEM
System Description
MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH
INPUT/OUTPUT SIGNAL CHART
POWER WINDOW OPERATION
• Power window system is operable during the retained power operation timer
after turning ignition switch ON
and O ...
Receiving a call
When a call is placed to the connected phone,
the display will change to phone mode.
To accept the incoming call, either:
● Press the button on the
steering
wheel, or
● Touch the icon on the screen.
To reject the incoming call, either:
● Press the button on the steer ...