Nissan Altima (L32) 2007-2012 Service Manual ≻ Security control system coupe ≻ Power supply and ground circuit ≻ Headlamp

Nissan Altima (L32) 2007-2012 Service Manual: Headlamp

Description

Headlamp lighting when theft warning system is alarm phase.

Component Function Check

1.CHECK HEADLAMP OPERATION

Check if headlamp operate by lighting switch.

Does headlamp come on when turning switch “ON”? YES >> Headlamp circuit is OK.

NO >> Check headlamp system. Refer to SEC-122, "Diagnosis Procedure".

Diagnosis Procedure

1.CHECK HEADLAMP OPERATION

Refer to EXL-40, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace.

2.CHECK INTER MITTENT INCIDENT

Refer to GI-42, "Intermittent Incident".

Is the inspection result normal? >> Inspection End.

Horn

Description Horn (high/low) is located inside of front bumper and operates when theft warning system is in alarm phase. Component Function Check 1.CHECK FUNCTION 1. Select HORN in “ACTIVE TES ...

Warning lamp

Description • Warning lamp is built in combination meter. • Intelligent Key system malfunction is reported to the driver by the warning lamp illumination. Component Function Check 1.CHECK ...

Other materials:

Fuel gauge
The gauge indicates the approximate fuel level in the tank. The gauge may move slightly during braking, turning, acceleration, or going up or down hills. The gauge needle returns to 0 (Empty) after the ignition switch is placed in the OFF position. The low fuel warning message shows in the vehic ...

Head restraints/headrests
WARNING Head restraints/headrests supplement the other vehicle safety systems. They may provide additional protection against injury in certain rear end collisions. Adjustable head restraints/ headrests must be adjusted properly, as specified in this section. Check the adjustment after someone else ...

Resetting the drive computer
The drive computer is divided across three screens: Speed Trip Distance & Time Fuel Economy 1. Press the or buttons until the desired drive computer screen is displayed. 2. Press the OK button to bring up the drive computer Reset menu. 3. Use the or to select the desired option. Then press ...